Amphenol RLA00571-25OR 조립 설명서 - 페이지 4

{카테고리_이름} Amphenol RLA00571-25OR에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphenol RLA00571-25OR 7 페이지. Assembly type connector

⑴

建议使用推荐线材（型号详见步骤1-1），如果客户选用其它电缆，请联系安费诺业务，协商订制零配件

Recommended cable should be used. （See section 1-1 for details.） If you need to use customized cable, Please contact

local sales for product extensions

⑵

压接高度和拉拔力需要配合压接截面的金相分析，客户才能判断压接质量合格,端子压接需要满足压缩比要求：80-90%。

Customers need to reconfirm cross section on crimping area and pull out force test to confirm the quality of crimp process,

Terminal crimping needs to meet the compression ratio requirements: 80-90%.

⑶

横截面仅供参考，客户负责采购压接工具或刀模

Cross section shape is only for reference, all crimping tools needed are supposed to be prepared by customers.

步骤3：将压好端子的端子组件如图示装入③下盖，再盖上①上盖将接头紧固好。

Step 5: Assemble the crimped terminal assembly into the ③ lower cover as shown in the figure, then cover the ①

upper cover and secure the connector.

③

Rev.00 20210811 Document No: 8P1147

RLA 5.7mm 组装式接头安装说明 The Assembly Manual for RLA 5.7 mm assembly type Connector

按住卡扣装入

确认此处无间隙

Press the button to assemble

Make sure no gap in

this area

03-05