Advanced MxPro 5 매뉴얼 - 페이지 11
{카테고리_이름} Advanced MxPro 5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Advanced MxPro 5 14 페이지. Pager interface
Advanced MxPro 5에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지), 애플리케이션 노트 (10 페이지)
페이지 인쇄
2.6 Pager Zones
Each Pager Address must be configured to
from which zones the events will be sent to the
This can be used to prevent unnecessary or
events being sent to all pagers or it can be used
only those zones that are relevant to a specific
For example, a nurse pager can be configured
only those zones concerned with the hospital
covered by the nurse.
Up to two ranges can be defined.
Right Click in the table or on a specific address
Delete / Edit and entry.
A new pop-up dialogue box is shown.
Define the new pager number and address
required. See example below.
2.7 Upload Communications
To upload the configuration data to the pager interface, first
cable from the base card and plug in the upload / download
shown opposite.
Click on the "Connect to Target" button and when
communications is established, click on the "Upload" button to
data.
On completion, remove the upload / download lead and re-fit
from the base card.
www.acornfiresecurity.com
If only one
range is
then use "Zonal Range 1" only.
The maximum zone range is 1 – 2000.
www.acornfiresecurity.com
define
pager.
unwanted
to define
person.
to cover
wards
to Add /
ranges as
address
required,
unplug the
lead as
transfer the
the lead
Pager Interface
11