Amphenol Temposonics MH Series 사용자 설명서 - 페이지 11

{카테고리_이름} Amphenol Temposonics MH Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphenol Temposonics MH Series 12 페이지. Analogue/pwm tester
Amphenol Temposonics MH Series에 대해서도 마찬가지입니다: 운영 매뉴얼 (18 페이지)

페이지 인쇄

3. Operations (continued)

3.3 Verification

Verify the sensor is reading the displacement of the magnet by moving the

magnet in the bench test of the attached sensor or by stroking the cylinder.

Observe the change in output reading.

3.4 Troubleshooting

No Power

1. Confirm the power switch is in 'ON' position

2. M-Series Tester my be in Low Power Mode

3. Plug in AC Power adapter and check the battery level

The sensor readings aren't showing on the display

1. Is the M-Series Tester in the correct mode?

2. Ìs the M-Series battery level above 9 Vdc?

3. Is the sensor connected to the appropriate terminals?

Error Message '[--]' is seen in PWM od PWM TOF mode

1. Make sure the correct plug is in the PWM port at the top of the M-Serie Tester

2. If in TOF mode, make sure the correct number or recirculations is selected

3. Check battery level to ensure the unit is providing a minimum of 9 Vdc to sensor

Note:

The M-Series Tester is not a calibrated device and should only be used for indi-

cation purpose only. The M-Series Tester is designed to be used to verify that

the sensor is functional after cylinder assembly and as a field troubleshooting

device. For field troubleshooting the tester is designed to isolate the sensor

from the rest of the vehicle in order to independently verify sensor functionality.

M-Series Tester

User's Manual

MTS Sensors