Amphenol Socapex RJSMLAC 8MG CAPS VAC 하드웨어 사용 설명서 - 페이지 5

{카테고리_이름} Amphenol Socapex RJSMLAC 8MG CAPS VAC에 대한 하드웨어 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphenol Socapex RJSMLAC 8MG CAPS VAC 14 페이지. Ip67/68 rugged ethernet managed switch
Amphenol Socapex RJSMLAC 8MG CAPS VAC에 대해서도 마찬가지입니다: 하드웨어 사용 설명서 (15 페이지)

Amphenol Socapex RJSMLAC 8MG CAPS VAC 하드웨어 사용 설명서
Section 3
As with any electronic device, you should place the switch where it will not be subject to
Selecting a
extreme temperatures, humidity, or electromagnetic interference that exceeds the
Site
RJSMLAC-8MG-CAPS
requirements:
CAPS for
The switches are pre-equipped with caps on all ports, including power and Ethernet.
unused
connectors
and prevent from deterioration of the contacts.
The RJSMLAC-8MG-CAPS Ethernet Switch can be fastened to any flat surface by
Mounting
mounting the box directly. Refer to the mechanical drawings below. Make sure to allow
enough room to route your Ethernet and power cables.
The RJSMLAC-8MG-CAPS weights 1.8 Kg and is mounted via its four 4x4.5 mm holes for
screws.
The external dimensions of the RJSMLAC-8MG-CAPS are given here after.
RJSMLAC 8MG CAPS UM

Installation

The ambient temperature should be between -35 to 75 degrees Celsius.
The relative humidity is recommended to be less than 95% percent, non-
condensing.
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards for MIL-STD-461E.
Make sure all connectors are protected with cap or sealed plug to ensure sealing
www.amphenol-socapex.com
's profile. Specifically, the site you select should meet the following
Rev: 4.0
Page 5 of 13
Tel : +33(0)4.50.89.28.00