Amphenol Telect nrgCONTROL-BT 설치 매뉴얼 - 페이지 3
{카테고리_이름} Amphenol Telect nrgCONTROL-BT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Amphenol Telect nrgCONTROL-BT 11 페이지.
페이지 인쇄Section One: Overview
The Amphenol Telect nrgCONTROL-BT coordinates and collects data for up to 30 nrgSMART enabled devices. Panels
are connected over a simple daisy chain connection. One IP address is all that is required for all attached PDU panels.
For new deployments the controller interface is built into the nrgBDFB. For expansion, single rack deployment or outdoor
enclosures, Amphenol Telect provides the 1RU controller.
The nrgCONTROL-BT is capable of connecting to DC power in the range of -20V to -57V. Redundant power input is also
configurable based on the pin-out description in Fig. 3.
Using nrgSMART's SNMP interface, pull data into your network management system of choice to get network wide
access and visibility to sites that deploy the nrgSMART controller/PDU panels. Get real-time data such as current,
voltage, breaker trips or blown fuses, and temperature for individual circuits. Uniquely identify and label assets to their
individual circuit. It is now possible to track performance based on asset.
Pin Number
Pin 1
Pin 2
Pin 3
Pin 4
nrgCONTROL-BT
Fig. 1: nrgCONTROL-BT front view
Fig. 2: nrgCONTROL-BT rear view without tie bar shown
Feed
Voltage Polarity
A feed
Positive voltage
A feed
Negative voltage
B feed
Positive voltage
B feed
Negative voltage
Fig. 3: nrgCONTROL-BT DC power pin out
All rights reserved. 07.20.2018 145122-4
3
Amphenol Telect
1-509-926-6000 — telect.com