Dover HYDRO DM-500 사용자 설명서 - 페이지 7

{카테고리_이름} Dover HYDRO DM-500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dover HYDRO DM-500 14 페이지. Warewash dispenser

페이지 인쇄

1. Electrical Installation and Programming

2.OO installation (continued)

2.O3 Mechanical Installation (continued)

Installing the Detergent Injection Fitting

1) When choosing a mounting locating, make sure that the detergent

infection fitting will be:

•

Above the water level of the filled wash tank.

•

Discharging detergent directly into the wash tank and not on top of

any shelf areas or other obstacles that could prevent detergent from

falling directly into the wash tank.

2. Previously punched holes may be suitable but always confirm that the

fitting is correctly placed. 10mm (3/8'') holes are common in Europe

and 22mm (7/8'') holes are common in North America. If an appropriate

hole is present, go to step 4.

3. If a hole is not available already, drill a 10mm (3/8'') hole at the center of

your chosen detergent injection location on the dish machine tank.

4. Remove the retaining nut from the supplied detergent injection fitting

and gather the gaskets and washers supplied with the unit.

5 a. For a 10mm (3/8'') hole insert the detergent injection fitting, with a

rubber gasket, into the hole you drilled earlier.

b. For a 22mm (7/8'') hole insert the detergent injection fitting, with a

large rubber gasket backed by a large stainless steel washer.

6. From the inside of the machine install a second rubber washer,

stainless backing washer if using a 22mm (7/8'') hole, and the retaining

nut. Tighten finger-tight, then snug using a wrench.

CAUTION!

Do not over-tighten the plastic retaining nut.

Installing the Rinse and Detergent Supply and Discharge Tubes

1) Install the included PVC pump supply tube (4mm ID, 6mm OD) into the chemical container using the foot filter with screen

and weight to position the tube at the bottom of the container.

2) Route the other end of the included PVC pump supply tubes from supply containers to the inlet sides (left) of each

respective pump. Slip the tube fully through the compression nut into fitting and tighten.

3) Route pump discharge tubes to the outlet sides (right) of each respective pump. Slip the tube fully through compression

nut into fitting and tighten.

4) Route the other end the pump discharge tube to the appropriate injection fitting (see the injection fitting installation

instructions on previous page for more detail). Slip the tube fully through the compression nut onto fitting nipple and

tighten.

NOTE: Try to keep both the supply and discharge hoses as straight as possible, avoiding all unnecessary bends.

Wash Tank

Wall

Outside

Inside

Compression

Nut

Outer

Inner

Rubber

Gasket

Outer

Steel Washer

(UL Only)

90° (Right Angle)

Detergent Injection

Fitting

(CE model shown)

Retaining

Nut

Inner

(UL Only)