Dahua VTO6110B 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Dahua VTO6110B에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahua VTO6110B 5 페이지. Fast operation of analogue villa system

Figure 3-5

3.2.2 Install door sensor

Figure 3-6

4 Issue Card

The device supports IC card with frequency 13.56MHz.

Press menu button on VTH to issue card. Press SOS button to switch menu and select to issue

card. VTH will then enter issuing card mode, and you will see prompt saying issuing card on

screen. Now swipe card at card reading area until you hear a beep which means you have

successfully issued card. Press touch button on VTO to exit.

1. When VTO connects to electric lock, make

electric lock + end toward VTO (03. 3-pin

1) NO end, and make electric lock – end

toward VTO (03. 3-pin 1) COM end.

2. When VTO connects to unlock button,

make unlock button's one end toward

VTO (04. 3-pin 2) ALM 1 end, and make

unlock button's other end toward VTO

(04.3-pin 2) GND end. See Figure 4-5.

When connect VTO to magnetic lock,

make magnetic lock + end toward VTO

(03.3-pin 2) NC end and magnetic lock –

end toward VTO (03. 3-pin 3) COM end.

2. When VTO is connected to door sensor of

magnetic lock, make door sensor's one

end toward VTO (04. 3-pin 1) ALM1 end to

unlock and make door sensor's other end

toward VTO (04. 3-pin 3) GND end. See

Figure4-6.