Dover TWG TULSA WINCH 506W 서비스 매뉴얼 - 페이지 9

{카테고리_이름} Dover TWG TULSA WINCH 506W에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dover TWG TULSA WINCH 506W 18 페이지.

페이지 인쇄

1. Thoroughly clean all parts. Replace those that show wear or damage.

(Item 5)

2. Inspect the drum

replace if necessary.

3. Attach the output shaft

making sure the vent

Torque Specifications Chart on page 15 of this manual)

4. Install the retaining ring

(Item 43)

5. Attach the rods

(Items 2 & 60)

. Torque to specification

manual)

6. If necessary, install a new bearing

7. Lay the unit down so that the rods

(Item 5)

onto the output shaft

8. Install the planet gearset

(Item 32)

onto the shaft

(Item 8)

9. Insert the sun gear

installed down, facing the output shaft.

(Item 7-4)

10. Install a new o-ring

into the bearing carrier

the drum.

11. Position the side plate

plate with eight capscrews

Chart on page 15 of this manual).

12. Install the brake subassembly into the side plate

(Item 21)

brake housing

(Item 26)

carrier

and that the holes for the motor are in the correct orientation. Also, make

sure that the level and vent plugs in the cover are properly oriented. Install one capscrew

(Item 65)

and five nuts

page 15 of this manual

(Item 7-2)

13. Install a new o-ring

valve assembly. Install two capscrews

(see Torque Specifications Chart on page 15 of this manual)

specification

(Item 46)

14. Reconnect the tube

15. Fill both the gearbox and the brake section with the proper amount and type of lubricants as

Recommended Oil

instructed in the

ASSEMBLY

for structural integrity and the gear teeth for excessive wear, then

(Item 32)

to the side plate

(Item 30)

is oriented properly, then torque them to specification

(Item 3)

onto the output shaft

(Item 12)

and base

(see Torque Specifications Chart on page 15 of this

(Item 28)

and oil seal

(Item 43)

and base

(Item 32)

being careful not to damage the seal

(Item 4)

into the drum

into the planet gearset

and, if necessary, a new bearing

(Item 26)

. Grease the o-ring and seal and install the bearing carrier into

(Item 1)

on top of the rods

(Items 2 & 60)

. Torque to specification

aligns with the bearing

and torque them to specification (

on the face of the motor and re-install the motor/counterbalance

(Item 51)

to the brake housing

section on page 6 of this manual.

(Item 50)

with six capscrews

(Item 32)

(Item 50)

to the side plate

(Item 7-8)

into the drum.

(Item 12)

are pointing up. Set the drum

(Item 5)

, making sure it's installed correctly

(Item 4)

. The slot in the sun gear must be

(Item 28)

(Item 43)

and base

(Item 12).

(see Torque Specifications

(Item 1)

, making sure that the pilot of the

(Item 28)

(Item 7-8)

and seal

see Torque Specifications Chart on

(Item 52)

and washers

(Item 21).

(Item 62)

(see

with eight capscrews

(Item 7-8)

and seal

Attach the side

in the bearing

(Item

and torque them to