Dover Hydro Connected Total Eclipse 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Dover Hydro Connected Total Eclipse에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dover Hydro Connected Total Eclipse 17 페이지.
페이지 인쇄
installation details (continued)
Cellular Gateway Installation (continued)
4) Connect the interface board (included in the gateway package) to the
Serial Port 2.
RS485
Interface
Board
This RS485 interface board may be installed on up to four Connected
TE controllers to establish communications with the gateway.
5) Using the provided interface cables (1 per Connected TE), daisy chain each cable splitter and Connected TE together, as
shown below.
The splitter closest to the gateway would be connected to the RS485 interface board via the long interface cable (provided
with the gateway).
The splitter furthest from the gateway should have its open port plugged with the provided terminator.
Gateway
RS485
Interface
Board
6) Install the two Cellular
Antennas by screwing
them onto the
threaded ports W1
and W3 as indicated.
7) With everything
connected, ensure
that the Power LED
illuminates
green
(see table to right)
and wireless signal
strength LEDs are
denoting Good or
Excellent.
Connection Pins
Controller 1
Controller 2
/ Node 1
/ Node 2
Cellular
Antenna
Connections
Serial Port
Controller 3
/ Node 3
LED Name
Color
USB
Green
SD
Green
Green
Power
Off
Green
LAN1/
LAN 2
Yellow
(RJ45
connector)
Off
Green
Wireless Signal
Yellow
Red
Strength
Off
USR
User-defined
Green
Green
Programmable
Yellow
diagnostic LEDs
Red
Serial Port 2
Controller 4
/ Node 4
Plug Splitter
into center
Terminator
Function
Steady On
USB device is connected and working normally.
Off
USB device is not connected.
Steady On
SD Card inserted and working normally.
Off
SD card is not detected.
Power is on and the computer is working normally.
Power is off.
Steady On
100 Mbps Ethernet link
Blinking
Data transmission in progress
Steady On
10 Mbps Ethernet link
Blinking
Data transmission in progress
Ethernet is not connected.
The number of glowing LEDs indicates the signal strength.
3 (Green + Yellow + Red): Excellent
2 (Yellow + Red): Good
1 (Red): Poor
Wireless module is not detected.
This LED can be defined by users. For details, refer to Hardware
User's Manual.
These three LEDs are programmable. For details, refer to the
"Default Programmable Button Operation" section in the Hardware
User's Manual.
port
5