Follett Horizon Elite 1810 Series 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} Follett Horizon Elite 1810 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett Horizon Elite 1810 Series 13 페이지. Ice machine models with ride technology
Follett Horizon Elite 1810 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (17 페이지), 매뉴얼 (8 페이지)
페이지 인쇄
Prepare the installation site.
Provide drainage, water supply and electrical power to within 6 feet (2m) of ice
machine in accordance with local and national codes. Outdoor installation is
not recommended and will void warranty.
2.1
2.1
Installation site requirements
Electrical
➊
• 120/60/1-5 amps
Potable water supply
➋
• 10-70 psi (69-483kpa)
• 45-90 F (7-32 C)
• Follett recommends the use of an in-line water filtration system (item# 00130286)
• This equipment is to be installed with adequate backflow protection to comply with applicable federal,
state, and local codes
➌
Drains:
3/4" Barb for silicone drain, 3/8" push-to-connect for chassis drain
• Minimum 8" radius on silicone drain line. Drain line from the ice machine must have at least 1/4" per foot
pitch (6,4mm/0,3m).
Refrigeration lines
➍
• 7/8" ∅ (22,4 mm) diameter suction line (insulated)
• 3/8" ∅ (9,5 mm) liquid line
BIN • TOP-MOUNT
➌
3/8"
drain must be
used
(3/8" push-in connection, 3/8" OD tubing required)
➎
remote condensing
chassis
➎
3/8" ∅ (9,5mm)
➍
7/8" ∅ (22,4 mm)
➍
➊
➋
1'
1/4" per foot
➌
(6,4 mm per 0,3 m)
➍
Site preparation
Minimum 8"
radius
2 ft. x 1" OD
silicone tubing
3/4" barb x 3/4" FPT
➌
3/4" MPT x 1" slip
1" Stand pipe/Drain
NEMA
5-15
2
5