Amplified Nation Wonderland OD 50 V2 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Amplified Nation Wonderland OD 50 V2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Amplified Nation Wonderland OD 50 V2 9 페이지.

Front Panel Functions

(CONTINUED)

Overdrive Switch: Switches the amplifier channel, sending the instrument signal through the overdrive

channel. To enable foot switch control of this function, this switch must be down.

PAB Switch: This switch bypasses the tone controls, increasing both level and mids. To enable foot

switch control of this function, switch must be down.

Reverb: The reverb control sets the level of reverb in the mix. The reverb effect is eliminated with this

control in the full counter clockwise position and increased when turned clockwise.

Contour Control: The contour control is similar to a 'cut' control. In the 12 o'clock position, the amps'

frequency response is flat. Counterclockwise rotation reduces high end

response and increases low frequencies. Counterclockwise rotation decreases low end and increases

the high frequency response.

Stand-by Switch: Should be in the "down" or "stand-by" position when you apply power to the unit.

After turning the A/C mains on, place the switch in the "up" position to use the amplifier. You may leave

the unit "powered up" and place this switch in the "stand-by" position to mute the output. Do not leave

the amp in standby for more than 30 minutes at a time.

Power Indicator Lamp: The replacement light bulb is a 6.3v A/C.

NOTE: All switches are ON in the "up" position