Amplified Nation Wonderland OD 50 V2 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Amplified Nation Wonderland OD 50 V2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Amplified Nation Wonderland OD 50 V2 9 페이지.

Rear Panel Functions

Mains: Connects the amplifier to A/C power with included IEC power cord.

Fuse:

See Fuse Chart page

Power Switch: Turns the A/C mains power on to the amplifier.

Bias Test Points: See bias adjustment section

Speaker Output Jacks: There are 4 speaker output jacks, two 4ohm, one 8ohm and one 16ohm. You

should only use one speaker impedance at a time, or two 4ohm outputs are to be used to power two

8ohm cabinets.

**Never operate your amplifier without a connected speaker load, and be sure to match the impedance

of your cabinet with the corresponding value on the amp.

Effects Loop: The effects loop of the Wonderland Overdrive is a passive signal access point. Any ef-

fects plugged into the loop will be run in series with the preamp and power amp.

Footswitch Jack: The footswitch connects with the included 7 pin locking cable. The functions of the

Wonderland Overdrive v2 include channel switching and preamp boost.