Follett EU155N Series 설치, 운영 및 서비스 매뉴얼 - 페이지 11
{카테고리_이름} Follett EU155N Series에 대한 설치, 운영 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett EU155N Series 20 페이지. Ice and water dispensers
Follett EU155N Series에 대해서도 마찬가지입니다: 설치 및 서비스 매뉴얼 (20 페이지), 설치, 운영 및 서비스 매뉴얼 (20 페이지)
페이지 인쇄Disassembly instructions for periodic cleaning
Dispense chute cover removal
1. Remove top cover.
2. Push chute cover up vertically to slip off holding
tab.
3. After clearing tab, pull chute cover forward to
remove.
Dispense mechanism assembly removal
1. Remove top cover.
2. Remove chute cover (see above).
3. Remove auger motor assembly (see above).
4. Remove quick release pins from the ice chutes
and gates, then unplug wires from solenoids.
5. Lift dispense mechanism up and off auger tube.
Auger and auger tube removal (Fig. 3)
1. Remove auger motor and dispense mechanism
assembly (see above).
2. Pull auger upward to clear auger tube.
3. Lift auger tube upward to clear dispenser top.
4. Slide tube and bearing plate through auger tube
gasket.
Dispense wheel removal
1. Remove drain pan assembly and bin access
cover.
2. Remove center thumbnut and threaded rod on
dispense wheel assembly and lift wheel out front
access opening.
Auger motor assembly removal
1. Remove top cover.
2. Remove one thumbnut on rear of motor bracket.
3. Lift motor bracket up and unplug electric quick
disconnects.
4. Remove motor assembly.
Fig. 1
Front view
right-hand unit
drain pan
assembly
Fig. 2
Dispense assembly, top view
right-hand unit
quick
release
pin
EU155N Ice and Water Dispensers
top cover
chute
cover
dispense
chute
solenoid
gate
ice chute
11