Amprobe TIC 300 PRO 사용자 설명서 - 페이지 13

{카테고리_이름} Amprobe TIC 300 PRO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe TIC 300 PRO 18 페이지. Meet the new standard in non-contact, high voltage detection
Amprobe TIC 300 PRO에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지), 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

MAINTENANCE AND REPAIR

If the TIC 300 PRO will not turn on, check the battery.

If there appears to be a malfunction during the

operation of the voltage detector, the following steps

should be performed in order to isolate the cause of the

problem:

1. Check the battery.

2. Review the operating instructions for possible

mistakes in operating procedure.

Except for the replacement of the battery, repair of

the voltage detector should be performed only by a

Factory Authorized Service Center or by other qualified

instrument service personnel. The front panel and

case can be cleaned with a mild solution of detergent

and water. Apply sparingly with a soft cloth and allow

drying completely before using. Do not use aromatic

hydrocarbons or chlorinated solvents for cleaning.

Battery Replacement

Use phillips blade screwdriver to remove the battery

hatch screw. Lift the hatch. Remove the battery and

replace it with a 9 volt alkaline battery. Make sure the

seal is in place. Close the battery hatch and replace the

screw.