Amprobe RTD-10 사용자 설명서 - 페이지 14

{카테고리_이름} Amprobe RTD-10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe RTD-10 19 페이지. Rtd

"TYPE"(Pt385/Pt3926/Pt3916) Second display Input

RTD Probe select

The Pt385/Pt3926 key switches the T2 input to select

the Pt385, Pt3926 or Pt3916 RTD probe as input, when

second display input selected T2. When the thermometer

is turned on, it is set to the RTD selected that was in use

when the thermometer was last turned off.

"Hi/Lo LIMITS" Mode (only Main display)

Press "Hi/Lo LIMITS" key to enter the Hi/Lo Limits

comparative mode. When the input temperature value

exceeds the Hi or Lo Limits value, the beeper emits a

continuous or pulsed tone. Press "Hi/Lo LIMITS" key

again to exit the Hi/Lo Limits mode.

Press the " " key for more than two seconds to start

wireless function. Press the " " key again for another

two seconds to stop wireless function. The wireless mode

will shut down if there is no wireless signal for two

minutes.

To SET CH/ID to 00,00, press the "Hi/Lo LIMITS" key and

" power key for more than 6 seconds with the meter

powered down. The meter will set channel and ID to

00,00 status. The second display will show 00, which

means that the channel and ID has been set to 00.

To check the channel and ID of the meter

When the meter is off, press "°C/°F" key and "

" for 5

seconds, LCD's main display will show channel number,

the second display will show ID number.