Amprobe TMD-51 사용자 설명서 - 페이지 10

{카테고리_이름} Amprobe TMD-51에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe TMD-51 15 페이지. Thermocouple thermometer k/j type with memory

" Button

Press the "

" key again to make the Back-Light lighter and press

" key once more to cancel the Back- Light function.

Back-Light on

Press the "HOLD" key to enter the Data Hold mode, the

"HOLD" annunciator is displayed at the higher-center of

display. When HOLD mode is selected, the thermometer

held the present readings and stops all further

measurements. Press the "HOLD" key again cancels

HOLD mode, causing thermometer to resume taking

measurements.

Press "TYPE" key to select the type of T/C, thermocouple

"K" or "J". Make sure the proper type has been selected.

Pressing and holding down "APO" key for 2 seconds to

trigger on or off APO(Automatic Power Off) mode, and

then APO annunciator will appear or disappear on the

display.

Power is automatically turned off, if no operation for a

period of time, and "APO" annunciator is displayed at

upper-left corner when APO function is enabled.

Press "MAX/MIN" key to enter the MAX MIN recording

mode. (Displays the Maximum reading, Minimum

reading, "MAX-MIN" reading stored in recording mode).

Press "MAX/MIN" key to cycle through the MAX, MIN,

MAX-MIN readings. In this mode, press "HOLD" key

to stop recording, all values are frozen, press again to

restart recording. In this mode, the APO function and

other keys is disabled, excluding "HOLD" and "

To prevent accidental loss of MAX, MIN and MAX-MIN,

in this mode can only be cancelled by pressing and

" key to trigger on the Back-Light. Press the

lighter

Back-Light off.

" keys.