Ampt ANALOGER ADG-1 사용자 설명서 - 페이지 7

{카테고리_이름} Ampt ANALOGER ADG-1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ampt ANALOGER ADG-1 20 페이지. 100% analog bucket brigade delay

Getting Started

Let's explore the range of controls of your ADG-1.

Connect your guitar or other instrument to the INput jack. Connect an

amplifier to the OUTput jack, and if you have an expression pedal (or 0-

5V control voltage source like a synthesizer output), connect it to the

EXPression input.

Use a 9V regulated 2.1mm, center-negative, power supply, capable of

providing at least 200mA of power and connect it to the 9V DC input.

Be sure to power up your ADG-1 BEFORE turning on your amplifier to

prevent speaker pop and the potential to damage your speakers or

headphones.

Note: If not using the expression input; be sure the expression switch is

NOT SET TO THE TIME POSITION to start. We recommend setting it

to AMT if not using this feature.

To start, set the ADG-1 to the

Home position as shown in the

graphics to the right.

Set TIME, MIX & TONE

straight up (12:00).

Set FEEDBACK, RATE &

AMOUNT switch fully counter-

clockwise (7:00).

Set DRIVE slightly up, around 9:00.

Set the Bucket and LFO switches to the down position.

There is no way to damage the ADG-1 through knob settings so feel free to

explore how the controls work. Go ahead, play with your ADG-1 and have

fun. There are some gotchas and advanced possibilities so once you are

done having fun read on to learn more about the ADG-1.

<7>