Amptek PC5 사용자 설명서 - 페이지 12

{카테고리_이름} Amptek PC5에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Amptek PC5 13 페이지.

5.4

Preamp Signal Connections

The schematic below illustrates how the preamp signal is brought to J7 for PA210/230 applications.

Figure 8. Preamp signal connections

PC5 Application Advice

6.1

Using the PC5 without a DP5

The PC5 must be ordered with the correct configuration. It is not intended for the user to change

configurations for different products.

XR100

When using the PC5 with an XR100 box the following configuration is needed:



Preamp power set to +/‐ 8.5 V (R16 = 0 Ohm/short, R18 = open).



J2 connector used to connect power to XR100.



VR1 and additional components installed for HV control (installed at the factory).



VR3 and additional components installed for temperature control (installed at factory).



XR100 Amp Out connected directly to user supplied signal processor.



Input power is applied either to J1 with the AC adapter or to J4 from a power supply.

PA‐210/PA‐230

When using the PC5 with a PA‐210 or PA‐230 the following configuration is needed:

Your

Products for

Imagination