CardAccess inhome IGA10A 설치 매뉴얼 - 페이지 6
{카테고리_이름} CardAccess inhome IGA10A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CardAccess inhome IGA10A 8 페이지. For monitoring and controlling garage doors and enabling automation events
페이지 인쇄6. (Optional) If you wish to use the External Thermistor (included in this package) to measure and create automation
events based on the outdoor temperature, perform the following steps:
a. Locate the External Thermistor on an outside garage wall within 10 feet of the InHome Wireless Contact
Switch.
b. Fish the wire pair from the External Thermistor back into the garage.
c. Connect the two tinned wires to the InHome Wireless Contact Switch's Tray Assembly Pins 2 and 4. It
does not matter which wire is connected to which pin. (please refer to the InHome Wireless Contact
Switch Installation Guide included with this Package and your Control4/Composer documentation for
additional installation details on how to use the Thermistor to generate events inside the Composer
Project).
Detailed Instructions for Automating Garage Door Operation
To install the needed hardware to support Control4 automation of garage door operation, please install the hardware
referenced in Figure 3 below as you complete the following steps:
Figure 3 – Garage Door Motor Drive to InHome Wireless Contact Relay Wiring Diagram
1. Add one InHome Wireless Contact Relay to the Garage room in the Composer Project and create the proper
bindings for two garage door motor drives (please refer to the InHome Wireless Contact Relay Installation Guide
included with this Package and your Control4/Composer documentation for additional installation details).
2. Using the included mounting screws and wall anchors, mount the InHome Wireless Contact Relay to a location
ideally located between the two garage door motor drives (please refer to the InHome Wireless Contact Relay
Installation Guide included with this Package for additional installation details).
_________________________________________________________________________________________________________________________
™
™
Card Access
InHome
Garage Automation Package Installation Guide / Wiring Diagram
Monitor and Control Garage Doors, and Enable Automation Events in the Control4-Automated Homes
Page 6 of 8
Card Access, Inc.