CardAccess inhome IGA10A 설치 매뉴얼 - 페이지 7
{카테고리_이름} CardAccess inhome IGA10A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CardAccess inhome IGA10A 8 페이지. For monitoring and controlling garage doors and enabling automation events
페이지 인쇄3. For each of the garage door motor drives, connect the garage door motor drives using standard AWG 18-28
wiring to the InHome Wireless Contact Relay's Tray Assembly using Pins 1 and 2 for garage door motor drive 1
and Pins 3 and 4 for garage door motor drive 2. (To determine which motor drive terminals should be used,
simply duplicate the wiring scheme from the motor drives to the existing garage door buttons already installed in
the garage area).
4. Connect any 9-24V AC/DC power supply to the InHome Wireless Contact Relay's Tray Assembly Pins + and – . If
you use a DC power supply (including the External 12V DC Power Supply included with the InHome Wireless
Contact Relay) you must match the polarity of the power supply to the proper + and – Tray Assembly Pin.
Suggested Automation Events
Now that the hardware is installed, you can use Control4 home automation system to monitor the open and closed states
of the garage doors, and actually open and close the garage doors. Using the Composer software you can add a wide
variety of events. Ideas for events include the following:
1. Changing the color on Control4 LED Keypad buttons to indicate the open and closed states of the garage doors.
2. Programming those same Control4 LED Keypad buttons to open and close the garage doors.
3. Creating audio events reporting the opening and closing of the garage doors.
4. Turning lights on inside the home when garage doors open.
5. Automatically closing the garage doors after they have remained open for a specific amount of time.
!!!
WARNING !!!: To prevent accidental closing of garage doors on
obstructed or otherwise occupied garage doorways, the InHome
Garage Automation Package MUST ONLY BE INSTALLED on garage
doors WITH "SAFETY BEAM" CAPABILITIES that are designed to
detect garage doorway obstructions and prevent door closure.
6. Automatically closing the garage doors at a particular time of day.
!!!
WARNING !!!: To prevent accidental closing of garage doors on
obstructed or otherwise occupied garage doorways, the InHome
Garage Automation Package MUST ONLY BE INSTALLED on garage
doors WITH "SAFETY BEAM" CAPABILITIES that are designed to
detect garage doorway obstructions and prevent door closure.
7. Activate an IP camera (not included) located at the garage door and use a camera preset to view activity in the
garage based on the open and closed states of the garage doors.
Product Support
If you have any difficulties, please contact Card Access Product Support at +1.801.748.4900, extension 15 weekdays
from 8am to 5pm Mountain Time for technical assistance.
_________________________________________________________________________________________________________________________
™
™
Card Access
InHome
Garage Automation Package Installation Guide / Wiring Diagram
Monitor and Control Garage Doors, and Enable Automation Events in the Control4-Automated Homes
Page 7 of 8
Card Access, Inc.