Cardax Prox Mifare Series 설치 참고 사항 - 페이지 4

{카테고리_이름} Cardax Prox Mifare Series에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cardax Prox Mifare Series 13 페이지. Teardrop
Cardax Prox Mifare Series에 대해서도 마찬가지입니다: 설치 참고 사항 (19 페이지)

페이지 인쇄

Note: The grommet through which the cables feed into the base of the Prox

Using the mounting dimensions on the back of this Installation Note as a guide,

drill a 20 mm (

mounting surface to a minimum depth of 40 mm (1

Drill two pilot holes for the fixing screws.

Run the building cabling through the base and grommet.

Fit the base to the 20 mm (

using two of the fixing screws provided.

Note: The surface the reader is being attached to will determine which length

WARNING: You must use the screws provided, taking care not to over-

tighten them. Make sure that the heads of the counter sunk screws are flush

with the top of the holes in the base, and ensure there is clearance for the screw

that closes the base and facia together.

Failure to do this, and/or using other types of screws could interfere with the

electronics.

Mifare Series (Teardrop) reader helps to keep the unit waterproof.

inch) diameter hole for the base extrusion through or into the

screws are most appropriate from those provided.

inch) hole and secure it to the mounting surface

in).

Part number 3E1100 R16

July 2010