DR Power Equipment PILOT 2C 안전 및 작동 지침 매뉴얼 - 페이지 13

{카테고리_이름} DR Power Equipment PILOT 2C에 대한 안전 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DR Power Equipment PILOT 2C 20 페이지. 2-cycle tiller cultivator

Chapter 4: Maintaining the DR 2-CYCLE TILLER CULTIVATOR

This chapter covers regular maintenance procedures that will ensure the best performance and long life of your DR 2-CYCLE

TILLER CULTIVATOR.

Prior to performing any maintenance, you must first shut off the Engine; wait five minutes to allow parts to cool and disconnect

the Spark Plug wire, keeping it away from the Spark Plug.

Regular Maintenance Checklist

Note: Consider that the service intervals shown are the maximum under normal operating conditions. Increase frequencies under

extremely dirty or dusty conditions.

Procedure

Check the Engine mixed Fuel Level

Clean the Tines and Tine Shield*

Check the general condition of the machine, e.g.

nuts, bolts, welds, etc.

Clean Engine Exterior & Cooling Fins

Clean Air Filter

Check Tines for Wear

Replace Air Filter

Replace Spark Plug

* Cover the Engine Muffler, Carburetor, and Air Filter before using a hose to clean the Tines and Tine Shield.

Lubrication

The Tines Drive Transmission Case has grease installed at the factory. We recommend that once a year to have the Transmission

opened by a qualified service professional and the grease level checked. Add a molylithium type grease only if the level of the

grease is below the top of the gears. DO NOT OVERFILL.

Before Each

Every 35

Use

Hours

▲

After each use

▲