DR Power Equipment PILOT 2C Güvenlik ve Kullanım Talimatları Kılavuzu - Sayfa 13

Tiller DR Power Equipment PILOT 2C için çevrimiçi göz atın veya pdf Güvenlik ve Kullanım Talimatları Kılavuzu indirin. DR Power Equipment PILOT 2C 20 sayfaları. 2-cycle tiller cultivator

Sayfayı Yazdır

DR Power Equipment PILOT 2C Güvenlik ve Kullanım Talimatları Kılavuzu

1. Chapter 6: Parts Lists and Schematic Diagrams

Chapter 4: Maintaining the DR 2-CYCLE TILLER CULTIVATOR

This chapter covers regular maintenance procedures that will ensure the best performance and long life of your DR 2-CYCLE

TILLER CULTIVATOR.

Prior to performing any maintenance, you must first shut off the Engine; wait five minutes to allow parts to cool and disconnect

the Spark Plug wire, keeping it away from the Spark Plug.

Regular Maintenance Checklist

Note: Consider that the service intervals shown are the maximum under normal operating conditions. Increase frequencies under

extremely dirty or dusty conditions.

Procedure

Check the Engine mixed Fuel Level

Clean the Tines and Tine Shield*

Check the general condition of the machine, e.g.

nuts, bolts, welds, etc.

Clean Engine Exterior & Cooling Fins

Clean Air Filter

Check Tines for Wear

Replace Air Filter

Replace Spark Plug

* Cover the Engine Muffler, Carburetor, and Air Filter before using a hose to clean the Tines and Tine Shield.

Lubrication

The Tines Drive Transmission Case has grease installed at the factory. We recommend that once a year to have the Transmission

opened by a qualified service professional and the grease level checked. Add a molylithium type grease only if the level of the

grease is below the top of the gears. DO NOT OVERFILL.

Before Each

Every 35

Use

Hours

▲

After each use

▲