AMS TMD2620 사용자 설명서 - 페이지 8
{카테고리_이름} AMS TMD2620에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMS TMD2620 14 페이지. Proximity sensor evaluation module
AMS TMD2620에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (5 페이지), 사용자 설명서 (13 페이지)
페이지 인쇄
The Reread Registers function forces the program to re-read all of the control registers from the
device and display them on the screen. This does not read the status or PROX result registers,
because those registers are continually read while the program is running.
Click on the Exit command to close the main window and terminate the application. Any unsaved
log data will be cleared.
2.1.3.2
Log Menu
The Log menu is used to control the logging function and to save the log data to a file. Log data is
accumulated in memory until it is discarded or written to a data file.
Click Start Logging to start the logging function. Each time the program polls the Prox information
from the device, it will create a new log entry showing the raw data values, the values of various
control registers, and the values entered by the user into the text fields near the bottom right corner
of the window.
Click Stop Logging to stop the logging function. Once logging is stopped, the data can be written to
a file, or you can continue collecting additional data by clicking Start Logging again.
The Log a Single Entry command will cause logging to start, collect one single entry, and
immediately stop again. This function is not available when logging is already running.
Click Clear Log to discard any data that has already been collected. If there is data in memory,
which has not been saved to disk, this function will display a prompt asking you to verify that it is OK
to discard the data. If the log is running when this function is clicked, the log will continue running
after the existing data is discarded.
Click Save Log to save the collected log data to a data file. This will stop the logging function, if it is
active, and display a file dialog box for you to specify where to store the logged data. The default
file name, as described above, will be displayed, but you may change the file name if you wish.
page 8/13