Bosch Apexx SHY99A 설치 지침 매뉴얼 - 페이지 17

{카테고리_이름} Bosch Apexx SHY99A에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Apexx SHY99A 34 페이지. Dishwasher
Bosch Apexx SHY99A에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (34 페이지), 설치 지침 매뉴얼 (21 페이지)

페이지 인쇄

Figure 12/Ilus. 12

Figure 13/Ilus. 13

Figure 14/Ilus. 14

Dishwasher Preparation | Préparatio du Lave-Vaiselle | Preparación - La Lavadora

DISHWASHER PREPARATION

(continued)

Removing the Toe Panel

Regular Toe Panel

The toe panel is loosely attached with

tape. Remove the tape and pull the toe

panel away from the dishwasher. Set

the toe panel aside. It will be reinstalled

later.

SHY66 and SHX56 Base and Toe Panel

The base and toe panel are in place on

the dishwasher, but are not attached.

Remove the toe panel first, as shown in

Figure 12, letter A, then remove the

base, as shown in Figure 12, letter B

Installing the 90° Elbow Fitting

NOTE: The 90° elbow fitting is not

supplied with the dishwasher, and

must be purchased separately. If the

dishwasher's hot water supply line is to

be copper tubing, make certain the

elbow has a compression fitting.

Apply Teflon tape or other pipe sealant

to all threaded connectors.

Orient the hot water supply connection

leg of the elbow toward the channel

opening in the dishwasher base.

Junction Box Preparation

1) Remove the junction box cover by

removing the screw on the left side of

the junction box, as shown in Figure 13,

letter C, and lifting the junction box

cover up and off.

2) Remove the strain relief plate by

removing the screw at the back of the

junction box, as shown in Figure 14,

letter D and sliding the strain relief

plate out.

3) Set the junction box cover, strain

relief plate, and screws aside. They will

be re-installed later.

E n g l i s h