DragonEye SPEED LIDAR 운영자 매뉴얼 - 페이지 5

{카테고리_이름} DragonEye SPEED LIDAR에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DragonEye SPEED LIDAR 10 페이지.

lower frequency tone. When the data from the vehicle reaches an

acceptable accuracy level, audible tone will switch to a continuous,

higher frequency and the vehicle speed reading will be displayed in

the HUD and on the back panel.

Note: At typical distances the above acquisition sequence can happen

very quickly and you may simply hear the high frequency tone and

see the speed display immediately.

A positive speed reading will be shown for an approaching vehicle,

while receding vehicles are indicated with a negative reading. (Note:

Both the HUD and the back panel will show a "-" sign for receding

vehicles.)

The DragonEye Speed LIDAR® will continuously update the target's

speed reading at an approximate rate of 3 times per second as long

as the trigger is depressed and the data quality is acceptable. While

not required, it is recommended to track the vehicle for at least 1

second to establish robust confidence in the speed reading.

Speed Display Lock

Once a desired speed reading is acquired, the operator can "lock"

the speed reading on the rear panel display by simply releasing the

laser fire trigger. If a speed reading is lost after tracking a vehicle,

the last speed reading will flash for approximately two seconds,

giving the operator an opportunity to lock in the vehicle's speed.

Note: The flashing speed reading will be immediately over written if

the operator acquires a new speed reading.

Speed Display Lock Retention

Once a speed is locked into the rear display, it will be retained there

for up to 20 minutes. If the laser fire trigger is depressed within 30

Canadian DragonEye Speed LIDAR

DragonEye Technology, LLC | Doc. 30508 Rev 05

Operator Manual