DragonEye SPEED LIDAR 운영자 매뉴얼 - 페이지 6

{카테고리_이름} DragonEye SPEED LIDAR에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DragonEye SPEED LIDAR 10 페이지.

Canadian DragonEye Speed LIDAR

Operator Manual

seconds after the speed is locked, the display will clear and prepare

for a new reading. If no buttons are pressed for 30 seconds after the

speed reading is locked, the unit will go into a sleep mode, turning

off the HUD and displaying "Power-Save" on the rear panel along

with the locked reading. In the Power-Save state, a first laser trigger

pull will "wake" the LIDAR but retain the locked reading. A second

pull will then clear the reading. This feature is intended to aid in

preventing the operator from accidentally clearing the locked

reading.

Range Mode

The LIDAR system can be used to measure distances to a variety of

targets. To enter Range Mode, press the Mode Button

until

the rear panels displays:

Use the aiming reticle in the HUD to select your desired target.

Squeeze and hold the trigger until a range reading is displayed in the

HUD and on the rear panel display. The trigger may be continuously

held as the unit is moved from target to target for quickly checking

multiple ranges. The last range reading in the display is locked when

the trigger is released. Range readings are displayed in tenths of a

metre on the rear panel and in the HUD up to 999.9 metres. Above

this, range readings are displayed to the nearest integer metre.

DragonEye Technology, LLC | Doc. 30508 Rev 05