DRAKE ENCODER HOST EH244 사용 설명서 - 페이지 5

{카테고리_이름} DRAKE ENCODER HOST EH244에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DRAKE ENCODER HOST EH244 20 페이지. Encoder host
DRAKE ENCODER HOST EH244에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지)

페이지 인쇄

INTRODUCTION

General Description

The Drake Digital EH244 Encoder Host is a platform for supporting Drake Digital modular MPEG2

and H.264 video encoders, including the SDE24A, HDE24, and SDI24A. The EH244 Encoder Host

multiplexes the outputs of the Encoder Modules into a digital output (QAM RF, ASI stream, or Internet

Protocol data stream - IP, depending on which EH244 model you have purchased) stream, configurable

via a front panel interface or Ethernet web server. The EH244 Encoder Host also includes provisions

for Emergency Alert System (EAS), using either video replacement or SCTE18 control messages.

The EH244 Encoder Host accepts up to 6 Drake Digital Encoder Modules, and allows each encoder's

output program to be included or excluded from the outgoing digital QAM RF Channels, IP program

data stream, or the ASI output stream (or a combination of these output formats). The EH244 Encoder

Host Series comes available in two base models that can be ordered with various output format

configurations tailored to your specific application requirements.

Models / Output Configurations

The EH244 Encoder Host Series is available in two standard models:

EH244-Q Quad QAM Encoder Host

This base unit outputs four (4) sequential Clear QAM RF channels.

EH244-IP (IP Output) Encoder Host

This base unit outputs a single (1) Internet Protocol (IP) data stream.

From these two base models, you may order alternate or additional output format configurations.

From the base EH244 Quad QAM Encoder Host, you may select the following additional output format

configuration:

EH244-Q-ASI Quad QAM / Quad ASI Encoder Host

This unit outputs four (4) ASI streams as well as four (4) Clear QAM RF channels.

The second base model in the EH244 Encoder Host Series, is the EH244-IP. The EH244-IP utilizes

a video codec to output MPEG transport streams encapsulated in a stream of IP (Internet Protocol)

packets. From the base model EH244-IP (IP Output) Encoder Host, you may select the following

additional output format configurations:

EH244-IP-ASI

Quad ASI / IP Encoder Host

This unit outputs four (4) ASI streams in addition to a single (1) IP data stream.

EH244-Q-IP

Quad QAM / IP Encoder Host

This unit outputs four (4) Clear QAM RF channels in addition to the single (1) IP data stream.

EH244-Q-IP-ASI Quad QAM / IP / ASI Encoder Host

This unit outputs four (4) Clear QAM RF channels in addition to the single (1) IP data stream

and four (4) ASI streams.

*NOTE: All models / Output Configuration Types of the EH244 Encoder Host Series will have a

separate isolated ASI Output Port. This separate ASI Output is a low-data ASI port used

only to output SCTE-18 data for EAS or DTA MODES when daisy-chaining several EH244

Series or EH24 Series models together in a headend (see Chapter 2, INSTALLATION AND

MOUNTING on Page 6 for specific information).

EH244 ENCODER HOST SERIES

(Part Number 1002568)

(Part Number 1002578)

(Part Number 1002569)

(Part Number 1002579)

(Part Number 1002580)

(Part Number 1002593)