DRAKE ENCODER HOST EH244 사용 설명서 - 페이지 7

{카테고리_이름} DRAKE ENCODER HOST EH244에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DRAKE ENCODER HOST EH244 20 페이지. Encoder host
DRAKE ENCODER HOST EH244에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지)

페이지 인쇄

INSTALLATION AND MOUNTING (continued)

Module Slot Number:

DTA - Modes (Digital Transport Adapter)

If the EH244 Series Encoder Host will be used as the 'master' in a DTA enabled system, a Drake

model ASII module must be installed in slot 6 (or slot 5, if the EH244 Series Encoder Host is also

being used as an EAS 'master' unit, using the Slot 6 Mode or Slot 6 + SCTE 18 EAS Mode). This

ASII module must be connected to the output of a PC that is generating the DTA control messages,

created by the Drake DTA Control software.

If the EH244 Series Encoder Host will be used as a 'slave' in a DTA-enabled system, a Drake model

ASII module must be installed in slot 6, and connected to the previous EH24 Series or EH244 Series

Encoder Host's single ASI Output.

*NOTE: For 'slave' systems using both DTA-Modes and EAS-Modes simultaneously, a single

Drake model ASII module will perform both functions.

Power Connection

Connect the AC line cord to an appropriate 120-240V, 50/60Hz AC power source. The EH244 Series

Encoder Host will always be powered and running as long as it is connected to its power source.

As an option, you may connect the EAS contact closure terminals to the output of an

EAS receiver to enable emergency alerts. Connect the ethernet control interface port to

a secured network or VPN for remote system configuration.*

EH244 ENCODER HOST SERIES

Image: Rear view of base model EH244-IP with Quad QAM RF Output

(continued on Page 8)