Dramm BP-4 운영자 매뉴얼 - 페이지 7

{카테고리_이름} Dramm BP-4에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dramm BP-4 15 페이지.

페이지 인쇄

3. Cleaning, Recharging, and Storage

Cleaning the inside of chemical tank

•After recovering the remnant solution, clean the inside of chemical tank by using clean water.

CAUTION

•Before cleaning, inspecting, and recharging, be sure to stop the BP-4.

Cleaning the pump inside with water

•After cleaning the inside of the chemical tank pour clean water into the tank again, run the pump, and clean the pump and

nozzle interiors until the sprayed mist of chemical solution is completely replaced with clean water.

Caution

•Leaving the pump interior without water-cleaning will cause failure of the pump and nozzles

•Clean the strainer

•Always drain water after cleaning unit

Caution

•Do not fail to drain the tank- otherwise the freezing of water may damage the pump in winter.

•After draining the chemical tank, grip the grip lever to run the pump without load until the remaining water in the tank is

completely discharged. Never continue the no-load run of the pump for longer than 1 minute- or pump may be damaged.

Recharging the battery

•Check the plug of the charger for damage, then insert it into the sprayer.

•Insert input plug to AC voltage.

•After full charge, pull out input plug from the AC voltage.

•Pull out plug of charger from the sprayer.

DANGER

Use the genuine charger and battery. Otherwise, the battery may rupture.

CAUTION

•Charge indoors in a cool area.

•Do not put anything on the charger.

•Do not let plug and electrical line short.

•Avoid water to the plug, electrical line, and charger.

•Do not run sprayer while charging.

•Do not remodel anything.

•Do not shake the charger during operation.

•Pull out AC input plug only when the charging operation is finished.

How to exchange the battery assembly

Should your battery need servicing, please take it to a dealer or distributor. Do not service it yourself.

Parts List

Part Location

Part Name

Bracket (rear)

Battery

Bracket (rear)

Fuse

Bracket (rear)

Harness

Bracket (front)

Cap

Bracket (side)

Cap

Bracket (side)

Battery tester

Pump Seal Set

Seal set

Pump

Seal packing retainer

Pump

Cap(yellow)

Pump A-Block

Piston packing

Pump B-Block

B Block Assembly

Pressure regulating valve O-Ring

Part #

127122

115385

124329

126247

126750

124328

641930

123256

116128

121434

599680

14180

Battery

Charging Time approx. 12 hrs.

Part Location

Part Name

Grip

O-Ring

Grip

O-Ring

Lance

Tandem Nozzle Head

Variable Nozzle Head

Chemical Tank

Chemical Tank Lid

Chemical Tank

Strainer

Back Carrying Band126308

Back pad

Recharging Unit

12V 5.0AH

Recharging Terminal

Part #

124612

14194

127253

117958

127460

125876

123217

123227

12799