Dramm BP-4 Посібник оператора - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник оператора для Фарборозпилювач Dramm BP-4. Dramm BP-4 15 сторінок.
Друкувати сторінку3. Cleaning, Recharging, and Storage
Cleaning the inside of chemical tank
•After recovering the remnant solution, clean the inside of chemical tank by using clean water.
CAUTION
•Before cleaning, inspecting, and recharging, be sure to stop the BP-4.
Cleaning the pump inside with water
•After cleaning the inside of the chemical tank pour clean water into the tank again, run the pump, and clean the pump and
nozzle interiors until the sprayed mist of chemical solution is completely replaced with clean water.
Caution
•Leaving the pump interior without water-cleaning will cause failure of the pump and nozzles
•Clean the strainer
•Always drain water after cleaning unit
Caution
•Do not fail to drain the tank- otherwise the freezing of water may damage the pump in winter.
•After draining the chemical tank, grip the grip lever to run the pump without load until the remaining water in the tank is
completely discharged. Never continue the no-load run of the pump for longer than 1 minute- or pump may be damaged.
Recharging the battery
•Check the plug of the charger for damage, then insert it into the sprayer.
•Insert input plug to AC voltage.
•After full charge, pull out input plug from the AC voltage.
•Pull out plug of charger from the sprayer.
DANGER
Use the genuine charger and battery. Otherwise, the battery may rupture.
CAUTION
•Charge indoors in a cool area.
•Do not put anything on the charger.
•Do not let plug and electrical line short.
•Avoid water to the plug, electrical line, and charger.
•Do not run sprayer while charging.
•Do not remodel anything.
•Do not shake the charger during operation.
•Pull out AC input plug only when the charging operation is finished.
How to exchange the battery assembly
Should your battery need servicing, please take it to a dealer or distributor. Do not service it yourself.
Parts List
Part Location
Part Name
Bracket (rear)
Battery
Bracket (rear)
Fuse
Bracket (rear)
Harness
Bracket (front)
Cap
Bracket (side)
Cap
Bracket (side)
Battery tester
Pump Seal Set
Seal set
Pump
Seal packing retainer
Pump
Cap(yellow)
Pump A-Block
Piston packing
Pump B-Block
B Block Assembly
Pressure regulating valve O-Ring
Part #
127122
115385
124329
126247
126750
124328
641930
123256
116128
121434
599680
14180
Battery
Charging Time approx. 12 hrs.
Part Location
Part Name
Grip
O-Ring
Grip
O-Ring
Lance
Lance
Tandem Nozzle Head
Variable Nozzle Head
Chemical Tank
Chemical Tank Lid
Chemical Tank
Strainer
Back Carrying Band126308
Back pad
Recharging Unit
12V 5.0AH
Recharging Terminal
Part #
124612
14194
127253
117958
127460
125876
123217
123227
12799