Draper Acumen V 설치 및 운영 지침 - 페이지 9

{카테고리_이름} Draper Acumen V에 대한 설치 및 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Acumen V 12 페이지. Electric projection screen 220v
Draper Acumen V에 대해서도 마찬가지입니다: 설치 및 작동 지침 (12 페이지)

페이지 인쇄

1. Section 1 - Electrical Connections

Acumen

XL E & V

™

Section 9 - Accessing Internal Low-Voltage Control Unit

PLEASE NOTE: Applies ONLY if Unit is built into case.

1. Using a 3/32" Hex Wrench, remove the screw from the wiring access door on the motor end of the case.

2. Remove the wiring access door and locate the Low Voltage Wiring Whip.

3. Make appropriate Low Voltage wiring connections

Low Voltage connection hole on the either the top or back of case.

4. Replace the access door and secure with screw using 3/32" Hex Wrench.

Remove

Access

. Low Voltage wiring should exit through the

(see Section 8)

Two electrical connection holes

are included in the screen housing

to separate Low-Voltage

and High-Voltage Wiring.

Low Voltage Wire

Door

(LVC-IV)

(closest to the motor endcap)

Electrical

Connection Holes

Low Voltage

Figure 13

page 9 of 10

High Voltage