Draper nocturne+ c 사용 설명서 - 페이지 3
{카테고리_이름} Draper nocturne+ c에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper nocturne+ c 10 페이지. Outdoor crank-operated projection screen
Draper nocturne+ c에 대해서도 마찬가지입니다: 설치 및 작동 지침 (4 페이지), 사용 설명서 (6 페이지), 설치 및 운영 지침 (8 페이지)
페이지 인쇄
Nocturne+ C
Section 2 - Mounting Case with Brackets
Caution: Mounting Brackets required for proper spacing of unit off the wall for Side Channel alignment.
1. Attach Mounting Brackets to the wall using #10 flat head screws installed flush with bracket.
Please Note: Be sure to use AT LEAST 2 of the top mounting holes.
2. Attach Headbox to brackets and tighten Set Screws.
3. Mount the Side Channels
(Section 4)
1
Figure 3
Section 3 - Mounting Case Directly to Wall
1. Attach Mounting Brackets to Case as a spacer between Case and wall.
Please Note: Leave a 1¾"
(44mm)
, and tighten set screws.
(Fig. 4)
2. Remove roller assembly.
A. Remove screws from bottom of Case, remove Cover and set aside
B. Remove Quick Release Pin from Idler End of Roller Assembly.
C. Remove Roller Assembly, Idler End first, and set aside.
3. Mount to Ceiling / Wall.
A. Using mounting holes in endcaps as a guide
both ends of Case.
B. Attach to mounting surface using appropriate fasteners.
Please Note: Installer is responsible for selecting mounting hardware
appropriate for site conditions.
4. Proceed to Section 4
.
(Installing Cable Guides)
Remove
A
cover.
B
Remove quick
release pin.
.
2
gap between Endcap and Mounting Bracket
, drill pilot holes on
(Fig. 6)
Figure 5
Remove roller
assembly.
3
Figure 4
.
(Fig. 5)
Leave a 1 "
gap.
(44mm)
C
Remove screws from
bottom of case.
Figure 2
Tighten
set screws.
Attach
mounting bracket
as spacer and
tighten set screws.
Figure 6
CEILING
CEILING
MOUNT HOLES
MOUNT HOLES
page 3 of 10
WALL
WALL
MOUNT HOLES
MOUNT HOLES