Draper Targa 사용 설명서 - 페이지 5

{카테고리_이름} Draper Targa에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Targa 8 페이지. Electrically operated projection screen with motor-in-roller
Draper Targa에 대해서도 마찬가지입니다: 설치 및 운영 지침 (4 페이지), 설치 및 운영 지침 (2 페이지), 설치 및 운영 지침 (2 페이지), 설치 및 운영 지침 (2 페이지), 설치 및 운영 지침 (4 페이지), 설치 및 운영 지침 (2 페이지), 설치 및 운영 지침 (3 페이지), 설치 및 운영 지침 (4 페이지), 설치 및 운영 지침 (2 페이지), 설치 및 운영 지침 (2 페이지)

페이지 인쇄
Draper Targa 사용 설명서
Targa

Section 5 - Accessing Internal Low-Voltage Control Unit

PLEASE NOTE: Applies ONLY if Unit is built into case.
1. Locate LVC-IV Unit.
2. Remove the two
star head screws from the motor end of the screen housing.
(2)
3. Remove the access panel with the LVC-IV from the screen housing.
PLEASE NOTE: Internal LVC-IV will increase overall case length by 1 13/16"
WIRING DIAGRAM -
Internal LVC-IV - Single or Multiple Projection Screen Wiring Diagram
INTERNAL SCREEN WIRING
Green/Yellow
(Motor Ground)
Red (Up)
Black (Down)
White (Common)
GND
N
To
110-120 VAC
L1
Line
Remove two (2)
screws from
endcap.
Internal LVC-IV - Single or Multiple
Internal LVC-IV
(Low-Voltage Control Module)
Projection Screen Wiring Diagram
Green/Yellow (Ground)
Red-to screen (directional)
Brown-to screen (directional)
White -Common to screen & 110V-120V AC Neutral
Yellow-to 110V-120V AC-Hot
Black-to 110V-120V AC-Hot
Location of key
operated on-off
switch if furnished.
Dashed wiring by electrician
Low-voltage wiring by others
Factory wiring

(LVC-IV)

.
(46 mm)
Remove
access panel
with LVC-IV.
*A second electrical connection hole
is included in the screen housing
in order to separate Low-Voltage
and High-Voltage Wiring.
Receiver
Button
3-Button Wall Switch
DOWN - Black
COM - White
UP - Red
Electrically Straight
Data Cable to more
LVC-IV modules.*
RS232/485
Inputs/Outputs
IR Eye Input
Low-Voltage
Trigger
4-28 VDC
page 5 of 8
Electrical
Connection
Hole*
Wall Switch
*A maximum of six (6)
LVC-IV modules can be
linked together.