Draper 15225 사용 설명서 - 페이지 5

{카테고리_이름} Draper 15225에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 15225 16 페이지. 2000w 230v hot air gun
Draper 15225에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

INTRODUCTION

Ideal for paint stripping, thawing etc. It is intended for domestic and light commercial use

only. Any other application is considered misuse.

Stock No... .......................................................................................................................... 15225

t r

. .

. . .

Rated voltage .............................................................................................................230V~50Hz

Rated input........................................................................................................................ 2000W

Temperature (approx.)

Setting 1 .....................................................................................................................50ºC

Setting 2 ...................................................................................................................450ºC

Setting 3 ...................................................................................................................600ºC

Air flow volume

Setting 1 ............................................................................................................. 500L/min

Setting 2 ............................................................................................................. 250L/min

Setting 3 ............................................................................................................. 500L/min

Weight (machine only) ..................................................................................................... 0.83kg

4.3 HANDLING & STORAGE

IMPORTANT: Please note this machine is fitted with a safety thermal overload protection. If

the product is used continuously too close to the work piece (i.e. misused) resulting in over

heating and the machine potentially catching fire, the thermal overload protection will be

activated and stop the heating element from operating within the machine. This will cause

the gun to blow cool air until the inner components of the heat gun have cooled sufficiently.

This process takes approximately 2 minutes. Repeat overloading will lead to permanent

damage.

Remember the nozzle will remain hot for sometime - a safe storage location should be used.

Store in a dry location out of the reach of children.

. . .

H .

F S