Draper Gen 2 Master Kit 사용 설명서 - 페이지 7
{카테고리_이름} Draper Gen 2 Master Kit에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Gen 2 Master Kit 8 페이지. Front hub wheel tool
페이지 인쇄
6
3.
REMOVING/INSTALLING BEARINGS AND PLATES
WARNING: Do not use powered or manual
impact tools when removing.
3.1 GENERAL INSTRUCTIONS
1.
Select correct size fitting/removal
plates and backing pad.
2.
Grease the force screw.
3.
Ensure you are using the correct
pin configuration.
4.
Follow vehicle or bearing
manufacturer's fitting guidelines.
Draper Tools will not be responsible
for damage caused by the incorrect
use of this tool.
3.1 REMOVING THE BEARING
1.
Select 4 or 5 pin configuration.
2.
Fit grey half moon plates
and backing plate.
3.
Assemble with a lubricated force
screw and nut.
4.
Turn the force screw with a spanner
(not supplied) while holding the
nut with a spanner (not supplied).
WARNING: Do not use powered or manual
impact tools when removing.
3.2 INSTALLING THE PLATES
1.
Select 4 or 5 pin configuration.
2.
Fit silver plates and push against
the locking ring.
WARNING: Do not push against the inner
bearing as this will overload the bearing.
Only apply press force to the outer
bearing ring.
3.
Assemble with screw, nut and
silver back plate and install by
turning screw and nut with
suitable spanners.
4.
Remove all tool parts.
SPANNER
FIG. 1
SPANNER
FIG. 2