Draper Gen 2 Master Kit Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Draper Gen 2 Master Kit. Draper Gen 2 Master Kit 8 pagina's. Front hub wheel tool
Pagina afdrukken
6
3.
REMOVING/INSTALLING BEARINGS AND PLATES
WARNING: Do not use powered or manual
impact tools when removing.
3.1 GENERAL INSTRUCTIONS
1.
Select correct size fitting/removal
plates and backing pad.
2.
Grease the force screw.
3.
Ensure you are using the correct
pin configuration.
4.
Follow vehicle or bearing
manufacturer's fitting guidelines.
Draper Tools will not be responsible
for damage caused by the incorrect
use of this tool.
3.1 REMOVING THE BEARING
1.
Select 4 or 5 pin configuration.
2.
Fit grey half moon plates
and backing plate.
3.
Assemble with a lubricated force
screw and nut.
4.
Turn the force screw with a spanner
(not supplied) while holding the
nut with a spanner (not supplied).
WARNING: Do not use powered or manual
impact tools when removing.
3.2 INSTALLING THE PLATES
1.
Select 4 or 5 pin configuration.
2.
Fit silver plates and push against
the locking ring.
WARNING: Do not push against the inner
bearing as this will overload the bearing.
Only apply press force to the outer
bearing ring.
3.
Assemble with screw, nut and
silver back plate and install by
turning screw and nut with
suitable spanners.
4.
Remove all tool parts.
SPANNER
FIG. 1
SPANNER
FIG. 2