Draper HG2000 사용 설명서 - 페이지 8
{카테고리_이름} Draper HG2000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper HG2000 12 페이지. 2000w hot air gun
페이지 인쇄
APPLICATIONS
The following instructions should only be used
as a guide as the ideal temperature should be
Fig.3
ascertained by performing a test on the
workpiece. Heating efficiency will vary
depending on the properties of the workpiece,
and the distance kept between the metal nozzle
and the workpiece.
IMPORTANT:
Please note this machine is fitted with safety
thermal overload protection. If the product,
for example, is used too close to the
workpiece - resulting in overheating, the
thermal overload protection will be
activated and stop the motor/heating of the
machine.
The hot air gun should be switched off and
disconnected from the power supply,
allowing the machine to totally cool down -
before restarting work.
Remember the nozzle will remain hot for
Fig.4
sometime - a safe storage location should be
used.
PAINT REMOVAL FROM WINDOW FRAMES Fig.4
IMPORTANT: Do not direct the hot air gun at
the glass during use as it may crack. Always
use the glass protection nozzle ✫✌ (not
supplied see optional accessories, page 9). Do
not touch the glass with the hot metal
protection nozzle. Repeat as above for paint
removal.
✫✌
HEATING AND SHAPING PLASTIC TUBING Fig.5
Fig.5
✬✌
Fit the reflector hook nozzle ✬✌ (not supplied
see optional accessories, page 9). Switch the hot
air gun on to the low heat setting (1), carefully
heat the tubing evenly moving it from side to
side.
- 7 -