Draper PT140K 사용 설명서 - 페이지 4

{카테고리_이름} Draper PT140K에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper PT140K 12 페이지. Multi-tool kit
Draper PT140K에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

페이지 인쇄

- Connecting to the Power Supply:

To eliminate the possibility of an electric shock your machine has been fitted with a BS approved, non

rewireable moulded plug and cable which incorporates a fuse, the value of which is indicated on the pin

face of the plug. If the plug is marked with the

approved BS1362 fuse must be used of the same amp rating. If the plug is not

with the

symbol,

should be used.

- The fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse cover is

required, ensure it is the same colour as that visible on the pin face of the plug (i.e. red). Fuse covers are

available from your Draper Tools stockist.

If the fitted plug is not suitable, it should be cut off and destroyed. *The end of the cable should now be

suitably prepared and the correct type of plug fitted. See below.

- *WARNING:

A plug with bare flexible wires exposed is hazardous if engaged in a live power socket outlet.

- WARNING: THIS APPLIANCE IS DOUBLE INSULATED.

- The mains lead is coloured Blue – Neutral, Brown – Live.

- As these colours may not correspond with the coloured markings identifying the terminals in your plug,

proceed as follows:

- The wire which is coloured blue must be connected to the terminal which is marked with the letter 'N' or

coloured black or blue.

The wire which is coloured brown must be connected to the terminal which is marked with the letter 'L' or

coloured red or brown.

- EXTENSION LEAD CHART:

Extension lead sizes shown assure a voltage drop of not more than 5% at rated load of tool.

Ampere rating

(on Name plate)

Extension cable length (Metres)

7.5

22.5

POWER SUPPLY

BS Kitemark, or both

symbol and the fuse needs replacing, an

and

BS Kitemark, of the same amp rating

Wire Size mm

0.75

- 3 -

marked, a fuse

1.0

1.25

1.0

1.5

1.0

1.5

1.25

1.5

2.5