Draper 51331 사용 설명서 - 페이지 9
{카테고리_이름} Draper 51331에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 51331 16 페이지. Bench grinders
페이지 인쇄
To correctly assemble, fit and adjust the tool
rests, spark deflectors and eye shields.
Carefully follow these instructions:
TOOL RESTS.
Attach the left and right hand tool rests ✳✌
using the four bolts ✴✌ and large washers ✵✌
as shown in Fig.6. Now adjust the tool rests so
there is approximately a 1.5mm (
between the surface of the grinding wheels
and the tool rests.
SPARK DEFLECTORS
Attach the two spark deflectors ✶✌ using the
two bolts ✷✌ and medium size washers ✹✌ as
shown in Fig.7. Now adjust the spark deflectors
so there is approximately a 1.5mm (
between the surface of the grinding wheels
and spark deflectors.
EYE SHIELDS
Place the eye shield frame ✺✌
over the eye shield ✻✌ fasten the
two parts together using the long
screws ✼✌, washers ✽✌ and nuts
✾✌. See Fig. 8.
Note: Do not overtighten as the
eye shield may crack.
Assemble the other eyeshield in
the same way.
Insert the shortest end of the
mounting rod ✿✌ a Fig.9 into the
hole ❀✌ in the shield frame ✺✌.
Now tighten the nut ❁✌ and round
headed bolt which are located in
the centre of each of the eye shield
mounting frames ✺✌. Fig.10 shows
the assembled eye shield
assembly.
ASSEMBLY (GHD150 & GHD200)
⁄
") gap
1
16
⁄
") gap
1
16
Fig.8.
Fig.9.
Fig.7.
✺✌
✿✌
❀✌
- 8 -
✴✌
✷✌
✻✌
Fig.10.
❁✌
Fig.6.
✳✌
✵✌
✶✌
✹✌
✺✌
✺✌