Draper 51331 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Szlifierka Draper 51331. Draper 51331 16 stron. Bench grinders

Drukuj stronę

To correctly assemble, fit and adjust the tool

rests, spark deflectors and eye shields.

Carefully follow these instructions:

TOOL RESTS.

Attach the left and right hand tool rests ✳✌

using the four bolts ✴✌ and large washers ✵✌

as shown in Fig.6. Now adjust the tool rests so

there is approximately a 1.5mm (

between the surface of the grinding wheels

and the tool rests.

SPARK DEFLECTORS

Attach the two spark deflectors ✶✌ using the

two bolts ✷✌ and medium size washers ✹✌ as

shown in Fig.7. Now adjust the spark deflectors

so there is approximately a 1.5mm (

between the surface of the grinding wheels

and spark deflectors.

EYE SHIELDS

Place the eye shield frame ✺✌

over the eye shield ✻✌ fasten the

two parts together using the long

screws ✼✌, washers ✽✌ and nuts

✾✌. See Fig. 8.

Note: Do not overtighten as the

eye shield may crack.

Assemble the other eyeshield in

the same way.

Insert the shortest end of the

mounting rod ✿✌ a Fig.9 into the

hole ❀✌ in the shield frame ✺✌.

Now tighten the nut ❁✌ and round

headed bolt which are located in

the centre of each of the eye shield

mounting frames ✺✌. Fig.10 shows

the assembled eye shield

assembly.

ASSEMBLY (GHD150 & GHD200)

⁄

") gap

⁄

") gap

Fig.8.

Fig.9.

Fig.7.

✺✌

✿✌

❀✌

- 8 -

✴✌

✷✌

✻✌

Fig.10.

❁✌

Fig.6.

✳✌

✵✌

✶✌

✹✌

✺✌