Dual Roller Coupled Motorized FlexShade
Section 5.4 - Intermediate Fabric/Roller Assembly
Please Note: Skip this section if your unit only has two panels
1. If desired, the proper location of the next bracket can be verified. Otherwise, proceed to step 2.
2. Install the next coupler bracket to mounting surface.
3. The end of the previously-installed coupler shaft should be flush with the outside edge of the bearing. If it
is extended beyond the bearing, you can retract the coupler shaft of the previously installed roller to the
intermediate position
(see "Operating the Retractable Shaft" and Fig. 5)
4. Lift both ends of the intermediate fabric/roller assembly into place and align between the rear/upper
brackets.
5. Installer #1 fully extends coupler shaft of previously installed roller by rotating the metal ring clockwise about
180° when viewing the face of the coupler assembly
shaft extends fully into the receiver of the fabric/roller assembly being installed.
6. Installer #2 extends the coupler shaft of the fabric/roller assembly being installed to the intermediate
position by rotating the ring clockwise about 120°
the shaft is flush with the outside edge of the bearing.
7. Operate the shade to ensure proper fabric tracking.
8. Lower the unit
(all shades will operate simultaneously)
9. If needed, the fabric panel heights can be adjusted so that the bottom edges of the fabric panels are aligned. On large
units, this procedure should be done on only one panel at a time to minimize the amount of fabric weight
that must be supported during the adjustment procedure.
Section 5.5 - Final
(Idler-end)
1. If desired, the proper location of the next bracket assembly can be verified. Otherwise, proceed to Step 2.
2. Install idler-end bracket assembly.
3. Retract coupler shaft of previously installed roller to the intermediate position
should be flush with the outside edge of the bearing.
4. Lift both ends of the idler-end fabric/roller assembly into place and align between the brackets.
5. Installer #1 places the idler-end sliding shaft onto the idler-end bracket
6. Installer #2 fully extends coupler shaft of previously installed roller by rotating
the metal ring clockwise about ½ of a turn when viewing the face of the
coupler assembly
(see "Operating the Retractable Shaft" and Fig. 5)
extends fully into the receiver of the idler-end fabric/roller assembly.
Caution: Ensure shaft is locked in place with retaining clip on shaft.
7. Operate the unit to ensure proper fabric tracking.
8. Lower the unit
(all shades will operate simultaneously)
9. If needed, the fabric panel heights can be adjusted so that the bottom edges
of the fabric panels are aligned. On large units, this procedure should
be done on only one panel at a time to minimize the amount of fabric
weight that must be supported during the adjustment procedure.
(See "Fabric/Roller Assembly Alignment" for instructions.)
10. Repeat steps followed for rear/upper fabric/roller assemblies under First
Fabric/Roller Assembly, Second Fabric/Roller Assembly and
(Operator-end)
Final
Fabric/Roller Assembly sections above for lower/front fabric/
(Idler-end)
roller assemblies.
(Fig. 8)
(see "Operating the Retractable Shaft" and Fig. 5)
(see "Operating the Retractable Shaft" and Fig. 5)
to lower limit.
Fabric/Roller Assembly
(Fig. 6)
, until the shaft
to lower limit.
®
(Extra Large Hardware)
.
, until the
so the end of
(See "Fabric/Roller Assembly Alignment" for instructions.)
(see "Operating the Retractable Shaft" and Fig. 5)
. Lock shaft in place by placing retaining clip on shaft.
(Fig. 6)
page 7 of 12
Figure 8
. The end of the coupler shaft
Figure 9
페이지 인쇄