Draper FlexShade NEXD 설치 및 운영 지침 - 페이지 3
{카테고리_이름} Draper FlexShade NEXD에 대한 설치 및 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper FlexShade NEXD 8 페이지. Clutch-operated small and large hardware
Draper FlexShade NEXD에 대해서도 마찬가지입니다: 설치 및 작동 지침 (6 페이지), 설치 및 운영 지침 (8 페이지), 사용 설명서 (8 페이지), 설치 및 운영 지침 (10 페이지), 사용 설명서 (12 페이지)
페이지 인쇄
Clutch-Operated FlexShade
Small and Large Hardware
PLEASE READ - Important Installation Information
Caution:
1. Inspect all boxes to make sure you have
received the proper shades and parts.
Controls may be shipped separately, or in
same carton as shades.
2. Open cartons lengthwise, taking care not
to cut into cardboard shipping container.
Section 1 - Mounting Endcaps
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
Please Note: The NEXD ships equipped for wall mounting. Product is field adjustable by installer from wall to ceiling mounting configuration,
and right hand to left hand operation.
Figure 1
Wall Mounting Endcap
1. Mark wall for placement of endcaps.
2. Drill small starter hole
(if necessary)
3. Attach idler and operator endcap covers to endcaps.
4. Mount endcaps using appropriate fasteners for surface.
(See Section 2 to convert between right and left mounting
configurations as needed.)
Figure 2
Ceiling Mounting Endcap
1. Mark ceiling for placement of endcaps.
2. Drill small starter hole
(if necessary)
3. Attach idler and operator endcap covers to endcaps.
4. Mount endcaps using appropriate fasteners for surface.
Figure 3
Jamb Mounting Endcap
1. Mark wall for placement of endcaps.
2. Drill small starter hole
(if necessary)
mounting surface.
3. Attach idler and operator endcap covers
to endcaps.
4. Mount endcaps using appropriate fasteners
for surface.
Please Note: If endcap covers are included in the
order, drill through the endcap cover and secure
with the endcap.
NEXD,
®
3. Before mounting shades, verify measurements
on label provided with shade, and ensure unit
is installed at correct width.
4. All endcaps, fascia, pocket headbox, and
other hardware must be installed level.
Shades must be level and square.
1.
Push endcap
covers onto
both endcaps.
in mounting surface.
1.
Push endcap
covers onto
both endcaps.
in mounting surface.
1.
Push endcap
covers onto
both endcaps.
in
6. Read the following installation guidelines
thoroughly and follow them carefully.
Failure to do so may cause product to fall or
otherwise fail, and invalidates warranty.
7. Installer is responsible for selecting mounting
hardware appropriate for site conditions.
2.
Mount
endcaps
to wall.
2.
Mount
endcaps
to ceiling.
2.
Mount
endcaps
to jamb.
page 3 of 8
PLEASE NOTE:
If endcap covers are
included in order,
drill through endcap
cover and secure
with endcap.
Endcap requires a
minimum of two
fasteners
.
(by others)
It is not necessary
to utilize all four
corners.