Draper FlexShade SkyLight 3 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} Draper FlexShade SkyLight 3에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper FlexShade SkyLight 3 6 페이지.
페이지 인쇄
SkyLight 3 Installation Instructions
Installing Roller/Fabric Assembly
Part One: Attaching Lower Sections of Motor Bracket (see fig. 7)
(1) Remove the Motor Ring from the Motor on the end of the Roller Assembly.
(2) Feed the Motor Cable through the Operator side of the Motor Mounting
Bracket.
(3) Attach the Operator Mounting Bracket to Motor and secure with Motor Ring.
(4) Attach the Idler Mounting Bracket.
B Remove
Motor Ring
C Feed Motor Cable
through the Operator
side of the Motor
Mounting Bracket
D Attach Bracket to Motor
and Secure with Motor Ring
WARNING :
The following procedure REQUIRES at least two (2)
installers to preform safely.
Part Two: Motor Cable Routing (see fig. 8)
(1) Feed Motor Cable through the Cable Exit hole (See Cable Exit Step (1)).
(2) Route the Motor Cable toward the back of the Motor Mounting Bracket
as shown in Fig. 8. This will ensure that the Motor Cable does not interfere
with the shade while in operation.
B Feed Motor Cable
through the Cable
Exit hole
C Route Motor Cable
toward the back of
the bracket as shown
Part Three: Installing Roller Fabric Assembly - (2 installers REQUIRED)
Figure (7)
E Attach Idler Bracket
Figure (8)
www.draperinc.com
(1) Lift the entire Roller Assembly up near the Motor Mounting Brackets and
insert the Hem Bar Rollers into the Side Channels (see Fig. 9).
Be sure to continuously pull the excess Motor Cable through the Cable Exit.
(2) With the Hem Bar inserted into both of the Side Channels, lift the Roller
Assembly up until the Lower Sections of the Motor Mounting Brackets
(attached to the ends of the Roller Assembly) are completely engaged with
the Upper Sections (mounted to the skylight frame).
R o l l
e r
A s s e
m b l y
D Re-tighten the four (4)
screws (2 per bracket)
using a hex wrench.
(3) Re-tighten the four (4) screws (2 per bracket) using a Hex Wrench.
(765) 987-7999
3
of
Figure (9)
B Insert Hem Bar
Rollers into
Side Channels
Figure (10)
C With the Hem Bar inserted into
the both of the Side Channels,
Lift the Roller Assembly up until the
Lower Sections of the Motor
Mounting Brackets are engaged with
the Upper Sections.
6