Draper FlexShade XL 설치 및 작동 지침 - 페이지 3

{카테고리_이름} Draper FlexShade XL에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper FlexShade XL 6 페이지. Very large motorized shading system. angled/curved headbox

페이지 인쇄

FlexShade

Section 1 - Preparation for Installation

1 Make sure mounting surface is strong enough to hold the FlexShade XL.

Please Note: It is the responsibility of installer to use appropriate fasteners for the mounting surface.

2 Verify unit measurements, and make sure it will fit in the desired location.

Please Note: The Hembar does not retract into the Headbox.

This will need to be accounted for if mounting over a swinging window or door.

3 Mounting brackets MUST be installed with a gap of 1¾" (45mm) between the End Cap and the Mounting Bracket

edge (See Fig. 1). Mark wall, jamb or ceiling. Brackets must be spaced no more than 5 feet (152cm).

4 Drill small starter holes (if necessary) in mounting surface.

Section 2 - Mounting Headbox with Brackets - Wall Installation

Attaching Mounting Brackets

1 Attach mounting brackets to the wall using #10 flat head screws

installed flush with bracket. Be sure to use AT LEAST 2 of the

top mounting holes (See Fig. 2).

2 Attach Headbox to brackets and tighten Set Screws (See Fig. 2).

3 You are now ready to mount the Side Channels (See Page 2).

Section 3 - Mounting Headbox with Bracket Ceiling Installation

Attaching Mounting Brackets

1 Attach mounting brackets to the ceiling using #10 flat head

screws installed flush with bracket.

Mounting bracket must be secured to the overhead building

structure (See Fig. 3).

2 Attach Headbox to brackets and tighten Set Screws (See Fig. 3).

Section 4 - Pocket Installation

The FlexShade XL can also be installed in a pocket in the ceiling.

The minimum depth of the ceiling pocket for installation of the FlexShade XL is 5

Figure 2

Figure 3

" (158mm). (See Fig 4).

page 3 of 6

MOUNTING

BRACKET

1¾"

(45mm)

E N

C A

Figure 1

Tighten Set Screws

(143mm)

(127mm)

Figure 4