Draper FlexShade XL Instrukcja instalacji i obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Wyposażenie wnętrz Draper FlexShade XL. Draper FlexShade XL 6 stron. Very large motorized shading system. angled/curved headbox
FlexShade
XL
®
Section 1 - Preparation for Installation
1 Make sure mounting surface is strong enough to hold the FlexShade XL.
Please Note: It is the responsibility of installer to use appropriate fasteners for the mounting surface.
2 Verify unit measurements, and make sure it will fit in the desired location.
Please Note: The Hembar does not retract into the Headbox.
This will need to be accounted for if mounting over a swinging window or door.
3 Mounting brackets MUST be installed with a gap of 1¾" (45mm) between the End Cap and the Mounting Bracket
edge (See Fig. 1). Mark wall, jamb or ceiling. Brackets must be spaced no more than 5 feet (152cm).
4 Drill small starter holes (if necessary) in mounting surface.
Section 2 - Mounting Headbox with Brackets - Wall Installation
Attaching Mounting Brackets
1 Attach mounting brackets to the wall using #10 flat head screws
installed flush with bracket. Be sure to use AT LEAST 2 of the
top mounting holes (See Fig. 2).
2 Attach Headbox to brackets and tighten Set Screws (See Fig. 2).
3 You are now ready to mount the Side Channels (See Page 2).
Section 3 - Mounting Headbox with Bracket Ceiling Installation
Attaching Mounting Brackets
1 Attach mounting brackets to the ceiling using #10 flat head
screws installed flush with bracket.
Mounting bracket must be secured to the overhead building
structure (See Fig. 3).
2 Attach Headbox to brackets and tighten Set Screws (See Fig. 3).
Section 4 - Pocket Installation
The FlexShade XL can also be installed in a pocket in the ceiling.
The minimum depth of the ceiling pocket for installation of the FlexShade XL is 5
Figure 2
Figure 3
5
/
" (158mm). (See Fig 4).
8
page 3 of 6
MOUNTING
BRACKET
1¾"
(45mm)
E N
D
C A
P
Figure 1
Tighten Set Screws
Tighten Set Screws
5
/
"
5
(143mm)
8
5"
(127mm)
5"
(127mm)
Figure 4