Draper Futureguard FlexShade Zip 설치 지침 매뉴얼 - 페이지 4
{카테고리_이름} Draper Futureguard FlexShade Zip에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Futureguard FlexShade Zip 7 페이지.
페이지 인쇄
Futureguard® FlexShade Zip™
Installing Side Channels on previously mounted Headbox
Preparation
1 Use 3mm Hex Wrench to remove
Screws from Side Channels and
set aside (See Fig. 9A).
2 Remove Side Channel Covers.
PLEASE NOTE: Do NOT remove
the Bottom Caps from Side
Channels.
3 For Jamb Mounting, also remove
the Zip Fabric Retainer Strip and
set aside.
4 Pre-drill through Side Channels
in at least three mounting points
(See Fig. 9B).
ATTACHING SIDE CHANNELS
See Step 6b on page 5 for Jamb Mounted Side Channels.
6a Insert the plastic Side Channel Top Guide and Fabric Retainers into
Side Channels (See Fig. 10).
Insert
Side
Channel
Top
Guide
Figure 10
S i
d e
C h
a n
n e
l
7a Slide the first Side Channel and Zipper Retainer onto one side of
the Hembar, guiding the Zipper into the Fabric Retainer in the Side
Channels (See Fig. 11).
8a With the Zipper engaged in Fabric Retainer, insert Side Channel
guide into bottom of the Headbox End Cap or over the End Cap
Peg, depending on the Headbox style (See Fig. 12).
9a Attach Side Channel to the mounting surface using appropriate
fasteners.
IMPORTANT: Side Channels MUST be installed parallel and square
with a tolerance of +/-
⁄
1
8
by Draper
If installing Zip 127 Angled Headbox, go to that section on page 5.
S i
C h
d e
a n
n e
l
Figure 9A
TO MOUNTED HEADBOX — SURFACE MOUTED SIDE CHANNELS
Angled leg of FABRIC
RETAINER STRIP must
be oriented towards back
U P
Side Channel Cross Section
" (3mm).
S i
C h
d e
a n
n e
l
10a Repeat Steps 7a-9a for
the other Side Channel.
11a Re-attach Side Channel
Covers using the
screws removed in Step
1 under Preparation.
PLEASE NOTE: Failure
to use provided
fasteners to re-attach
Side Channel Covers
may result in product
failure in high wind.
Figure 12
J a
m b
P i
l o t
Neoprene cushions
on the retainer strip
(shown in black)
ARE NOT TO
Figure 9B
BE REMOVED.
If they come off,
replace using
double-sided tape.
Wall Mounting
Wall Mounting
Front of Shade
S i
d e
C h
a n
n e
l
Figure 11
End Cap
Side
Channel
Guide
Side
Channel
page 4
M o
J a
u n
H o
t
m b
l e
P i
M o
l o t
u n
H o
t
l e
Jamb Mounting
Jamb Mounting
Front of Shade
ZIPPER
Side
Channel
Guide
HEMBAR
FABRIC
RETAINER
S i
STRIP
d e
C h
a n
n e
l
End Cap
Side Channel
Guide Properly
Engaged
in Headbox