Draper LightBloc FlexShade 설치 및 작동 지침 - 페이지 5
{카테고리_이름} Draper LightBloc FlexShade에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper LightBloc FlexShade 8 페이지.
페이지 인쇄
LightBloc FlexShade
Section 4 - Bead Chain Limits and Safety Device Installation
(for Units with Clutch or Spring Roller Operation)
Section 4.1 - Attaching Stop Balls
1.
Set upper and lower travel limits by installing stop balls to bead chain
Section 4.2 - P-Clip Cord Tension Device
Please Note: Draper Bead Chain Clutch Operated shades that do not comply with WMCA/ANSI Standard
A100.1-2012 come with a cord tension device pre-attached to bead chain
must be attached to wall, jamb or sill so that bead chain is held taut enough that children
cannot pull it away from wall or fit their head into loop.
Section 4.3 - Spring-Loaded Cord Tension Device
Draper LightBloc FlexShade complies with WMCA/ANSI Standard A100.1-2018, a Spring-Loaded Cord
Tension Device comes installed on bead chain
mechanical fasteners
(wood screws)
away from wall or fit their head into loop.
For more information, visit
www.draperinc.com/WindowShades/WCMAcompliance.asp.
Please Note: Over-tightening screws will damage Spring Loaded Tension Device.
Section 5 - Check Shade Operation
Attach bead chain to slat bar and catch to sill channel. To operate shade, pull
down, locking in place using the bead chain
®
(Fig.
9). An approved permanent warning label and approved
are included. Device is designed so that children cannot pull bead chain
(See safety note on page
2).
(for Units with Clutch or Spring Roller Operation)
(Fig.
11).
(crimp closed using pliers) (Fig.
7).
(Fig.
8). This device
Figure 10
Catch
page 5 of 8
Figure 7
Figure 8
Attach
Stop Balls
Crimp
Closed
with
Pliers
Figure 9
Sill
Mount
Tensioner
Slat Bar
Sill Channel
Jamb
Mount