Draper Motorized FlexShade 사용 설명서 - 페이지 4
{카테고리_이름} Draper Motorized FlexShade에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper Motorized FlexShade 12 페이지. Motor operated window shades with several control options
Draper Motorized FlexShade에 대해서도 마찬가지입니다: 설치 및 작동 지침 (8 페이지)
페이지 인쇄Motorized FlexShade
Section 3 - Surface Headbox Installation
Please Note: If unit is to
be installed without
Surface or Pocket
Headbox, please
proceed to Section 5.
1.
Slide endcaps and coupler
cover piece of surface headbox.
A
. Begin with one end.
(Motor End shown)
2.
Using pre-drilled
holes in endcaps,
mark headbox
for drilling.
3.
Drill holes in back
or top
(wall mount)
of top/back cover of
mount)
surface headbox.
®
(Coupled)
(Optional)
Caution: Before mounting
shades, verify measurements
on the card provided with
the shade, and ensure the
endcaps are installed at the
correct width.
into top/back
(s)
B
LOREM IPSUM
(ceiling
Please Note: Installer
must provide adequate
clearance for removal
of Roller Assembly
during installation and
maintenance.
. Slide coupler
(s)
into headbox.
4.
Attach endcaps, coupler, and
top/back cover piece to wall
or ceiling, using mounting
hardware appropriate
for site conditions.
Please Note: A minimum of
two
(2)
for each endcap.
5.
Next, mount Roller Assembly
as shown in Section 5.
Please Note: Headbox
MUST BE mounted directly
to ceiling or wall, or to
a continuous blocking
that has been secured to
building structure.
C
. Slide opposite side
endcaps into headbox.
(Idler End shown.)
screws is required
page 4 of 12