Draper Motorized FlexShade Talimatlar Kılavuzu - Sayfa 4

İç Mekan Mobilyaları Draper Motorized FlexShade için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper Motorized FlexShade 12 sayfaları. Motor operated window shades with several control options
Ayrıca Draper Motorized FlexShade için: Kurulum ve Çalıştırma Talimatları (8 sayfalar)

Sayfayı Yazdır
Motorized FlexShade

Section 3 - Surface Headbox Installation

Please Note: If unit is to
be installed without
Surface or Pocket
Headbox, please
proceed to Section 5.
1.
Slide endcaps and coupler
cover piece of surface headbox.
A
. Begin with one end.
(Motor End shown)
2.
Using pre-drilled
holes in endcaps,
mark headbox
for drilling.
3.
Drill holes in back
or top
(wall mount)
of top/back cover of
mount)
surface headbox.
®
(Coupled)

(Optional)

Caution: Before mounting
shades, verify measurements
on the card provided with
the shade, and ensure the
endcaps are installed at the
correct width.
into top/back
(s)
B
LOREM IPSUM
(ceiling
Please Note: Installer
must provide adequate
clearance for removal
of Roller Assembly
during installation and
maintenance.
. Slide coupler
(s)
into headbox.
4.
Attach endcaps, coupler, and
top/back cover piece to wall
or ceiling, using mounting
hardware appropriate
for site conditions.
Please Note: A minimum of
two
(2)
for each endcap.
5.
Next, mount Roller Assembly
as shown in Section 5.
Please Note: Headbox
MUST BE mounted directly
to ceiling or wall, or to
a continuous blocking
that has been secured to
building structure.
C
. Slide opposite side
endcaps into headbox.
(Idler End shown.)
screws is required
page 4 of 12